What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two.)

选择了： when Carrier Sense Multiple ccess/Collision Detection is used、when the cable length limits are exceeded

选择了： when one side of the connection is configured for half-duplex、when the sending device waits 15 seconds before sending the frame again、when a collision occurs after the 32nd byte of a frame has been transmitted、when the cable length limits are exceeded

选择了： when one side of the connection is configured for half-duplex、when the sending device waits 15 seconds before sending the frame again、when a collision occurs after the 32nd byte of a frame has been transmitted

选择了： when one side of the connection is configured for half-duplex、when the sending device waits 15 seconds before sending the frame again、when the cable length limits are exceeded

选择了： when one side of the connection is configured for half-duplex、when the sending device waits 15 seconds before sending the frame again

选择了： when one side of the connection is configured for half-duplex、when a collision occurs after the 32nd byte of a frame has been transmitted、when the cable length limits are exceeded

选择了： when one side of the connection is configured for half-duplex、when a collision occurs after the 32nd byte of a frame has been transmitted

选择了： when one side of the connection is configured for half-duplex、when the cable length limits are exceeded

选择了： when the sending device waits 15 seconds before sending the frame again、when a collision occurs after the 32nd byte of a frame has been transmitted、when the cable length limits are exceeded

选择了： when the sending device waits 15 seconds before sending the frame again、when a collision occurs after the 32nd byte of a frame has been transmitted